The standard program contains three different geometry's for receipting the studs of a shaft: A1 (fig. 1), A2 (fig. 2), A3 (fig. 3). The sizes are given in the table listed below. The tolerance field of the geometry 's A2 en A3 is within H7. The receptacle of the A1 type lays within 0/+1 mm.
Besides the below shown safety chucks with pedestal, all type are also available as flange safety chuck. Even sliding is available on each type, this gives you the opportunity to guide the role.
Hand wheel securance, guide for disc for sliding, conical receptacle of the stud, high speed safety chuck,pedestal for moving along the web. Just ask us for all the possibilities.